Iei-integration WAFER-945GSE2 v1.03 Uživatelský manuál Strana 80

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 204
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 79
WAFER-945GSE2 User Manual
Page 63
Jumper Label: ATXCTl1
Jumper Type:
3-pin header
Jumper Settings:
See
Table 5-2
Jumper Location:
See
Figure 5-3
The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX. Use a
jumper cap to short pin 1 - pin 2 on the ATXCTL1 connector to enable the AT Power mode
on the system. In the ATX mode use the PS_ON- and 5VSB cable. AT/ATX Power Select
jumper settings are shown in
Table 5-2.
AT Power Select Description
Short 2 – 3 Use AT power Default
OFF Use ATX power
Table 5-2: AT/ATX Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 5-3 below.
Figure 5-3: AT/ATX Power Select Jumper Location
Zobrazit stránku 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 203 204

Komentáře k této Příručce

Žádné komentáře