Iei-integration NANO-QM770 Uživatelský manuál stáhnout pdf (Strana 71)

NANO-QM770 EPIC SBC

Page 56

Figure 4-14: Single RS-232 Cable Installation

Step 3: Secure the bracket. The single RS-232 connector has two retention screws

that must be secured to a chassis or bracket.

Step 4: Connect the serial device. Once the single RS-232 connector is connected to

a chassis or bracket, a serial communications device can be connected to the

system. Step 0:

4.8 External Peripheral Interface Connection

Devices can be connected to the external connectors. To install external devices, follow

the directions in the subsections below.

4.8.1 DVI Display Device Connection

The NANO-QM770 has a single female DVI-I connector on the external peripheral

interface panel. The DVI-I connector is connected to a digital display device. To connect a

digital display device to the NANO-QM770, please follow the instructions below.

Step 1: Locate the DVI-I connector. The location of the DVI-I connector is shown in

another chapter.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 189 190

Žádné komentáře

Iei-integration NANO-QM770 Uživatelský manuál Strana 71