
IMBA-Q454-R10 User Manual
Page 74
4.4.2 iTPM Setup Jumper
Jumper Label: JTPM1 and JTPM2
Jumper Type:
2-pin headers
Jumper Settings:
See 8Table 4-2
Jumper Location:
See 8Figure 4-8
The iTPM setup jumper settings are shown in
8Table 4-2. Close pins 1 and 2 on both
JTPM1 and JTPM2 to enable iTPM. All other settings disable iTPM.
AT Power Select Description
Open 1 - 2 Disable iTPM Default
Short 1 - 2 Enable iTPM
Table 4-3: iTPM Setup Jumper Settings
The location of the clear CMOS jumper is shown in 8Figure 4-8 below.
Figure 4-9: iTPM Setup Jumper Locations
4.5 Chassis Installation
To install the IMBA-Q454-R10 motherboard into the chassis please refer to the reference
material that came with the chassis.
Komentáře k této Příručce