Iei-integration IMBA-C2260-i2 Uživatelský manuál stáhnout pdf (Strana 87)

IMBA-C2260-i2 ATX Motherboard

Page 70

4.6 Internal Peripheral Device Connections

This section outlines the installation of peripheral devices to the onboard connectors.

4.6.1 SATA Drive Connection

The IMBA-C2260-i2 is shipped with two SATA drive cables. To connect the SATA drives

to the connectors, please follow the steps below.

Step 1: Locate the connectors. The locations of the SATA drive connectors are shown

in Chapter 3.

Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA

drive connector until it clips into place. See

Figure 4-15.

Figure 4-15: SATA Drive Cable Connection

Step 3: Connect the cable to the SATA disk. Connect the connector on the other end

of the cable to the connector at the back of the SATA drive. See

Figure 4-16.

Step 4: Connect the SATA power cable. Connect the SATA power connector to the

back of the SATA drive. See

Figure 4-16. Step 0:

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 226 227

Žádné komentáře

Iei-integration IMBA-C2260-i2 Uživatelský manuál Strana 87