Iei-integration IMBA-C2060 v2.01 Uživatelský manuál stáhnout pdf (Strana 74)

IMBA-C2060 ATX Motherboard

Page 58

4.3 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.

Description Label Type

AT/ATX power select ATX_AT1 2-pin header

Clear CMOS jumper J_CMOS1 3-pin header

Wake-on LAN WOL_SEL1 3-pin header

Table 4-1: Jumpers

4.3.1 AT/ATX Power Select Jumper

Jumper Label: ATX_AT1

Jumper Type:

2-pin header

Jumper Settings:

See Table 4-2

Jumper Location:

See Figure 4-8

The AT/ATX Power Select jumper specifies the systems power mode as AT or ATX.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 208 209

Žádné komentáře

Iei-integration IMBA-C2060 v2.01 Uživatelský manuál Strana 74