Iei-integration PICOe-945GSE Uživatelský manuál Strana 115
- Strana / 197
- Tabulka s obsahem
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
PICOe-945GSE Half-Size CPU Card
Page 115
Compatible D
EFAULT
Configures the on-board ATA/IDE controller to be in
compatible mode. In this mode, a SATA channel will
replace one of the IDE channels. This mode supports up
to 4 storage devices.
Enhanced
Configures the on-board ATA/IDE controller to be in
Enhanced mode. In this mode, IDE channels and SATA
channels are separated. This mode supports up to 6
storage devices. Some legacy OS do not support this
mode.
Legacy IDE Channels [PATA Pri, SATA Sec]
SATA Only
Only the SATA drives are enabled.
SATA Pri, PATA Sec D
EFAULT
The IDE drives are enabled on the Primary
IDE channel. The SATA drives are enabled on
the Secondary IDE channel.
PATA Only
The IDE drives are enabled on the primary
and secondary IDE channels. SATA drives
are disabled.
IDE Master and IDE Slave
When entering setup, BIOS auto detects the presence of IDE devices. BIOS displays the
status of the auto detected IDE devices. The following IDE devices are detected and are
shown in the IDE Configuration menu:
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
- PICOe-945GSE 1
- Revision 2
- Copyright 3
- Manual Conventions 4
- Table of Contents 7
- List of Figures 13
- List of Tables 16
- List of BIOS Menus 18
- 1 Introduction 19
- 1.1 Overview 20
- 1.2 PICOe-945GSE Overview 21
- Page 22 22
- Page 24 24
- Serial Infrared (SIR) 25
- 2 Detailed Specifications 26
- 2.1 Dimensions 27
- 2.2 Data Flow 28
- 719HFigure 30
- 721HFigure 2-6 32
- 2.5 Intel 36
- ICH7-M Southbridge Chipset 36
- 33 MHz 38
- 724HFigure 2-11 below 40
- 2.6 LPC Bus Components 42
- 3 Unpacking 47
- 3.1 Anti-static Precautions 48
- 3.2 Unpacking 48
- 3.3 Unpacking Checklist 49
- 4 Connectors 51
- Page 52 52
- 4.1.1 PICOe-945GSE Layout 52
- Page 54 54
- 2 PS-ON 55
- 3 +5V Standby 55
- 1 HDA_SYNC 2 HDA_BITCLK 56
- 3 HDA_SDOUT 4 SB_SPKR 56
- 5 HDA_SDIN0 6 HDA_RST# 56
- 7 VCC 8 GND 56
- 9 +12V 10 GND 56
- 1 LCD Backlight Control 57
- 2 GROUND 57
- 4 GROUND 57
- 5 BACKLIGHT Enable 57
- Page 58 58
- 4.2.4 CompactFlash® Socket 58
- 747HFigure 4-7 59
- 748HTable 4-7 59
- 1 GND 2 VCC 60
- 3 Output 3 4 Output 2 60
- 5 Output 1 6 Output 0 60
- 7 Input 3 8 Input 2 60
- 9 Input 1 10 Input 0 60
- 751HFigure 4-9 61
- 752HTable 4-9 61
- 3 IR-RX 63
- 5 IR-TX 63
- 789H757HFigure 4-12 64
- 790H758HTable 4-12 64
- Page 66 66
- 793H761HFigure 4-14 67
- 794H762HTable 4-14 67
- 4.2.14 SDVO Connector 69
- 4.2.15 TV Out Connector 71
- 1 GND 2 AGREEN_Y 72
- 3 GND 4 ARED_C 72
- 5 GND 6 ABLUE_CVBS 72
- 772HFigure 4-19 74
- 2 DATA 76
- 3 DATA+ 76
- Figure 4-22: VGA Connector 77
- 5 Installation 78
- 5.1 Anti-static Precautions 79
- Read the user manual: 80
- 5.2.2 Installation Checklist 81
- 5.3 Unpacking 82
- 784HFigure 5-1) 83
- 785HFigure 5-1) 83
- 786HFigure 5-2 83
- 788HTable 5-2 85
- 789HFigure 5-4 85
- 790HTable 5-2 85
- Load Optimal Defaults 87
- 832H798HTable 5-4 88
- 833H799HFigure 5-6 below 88
- 800HTable 5-5 88
- 801HFigure 5-7 88
- 802HTable 5-5 88
- Short 2-3 +5V LVDS 90
- 5.5.6 PCIe Status Select 91
- 5.6 Chassis Installation 92
- SATA power cable 93
- Parallel port cable 93
- HDTV out cable 94
- 5.1 channel audio kit 94
- 7.1 channel audio kit 94
- [email protected] 95
- 5.7.4 SATA Drive Connection 97
- Page 98 98
- 818HFigure 5-14 99
- Page 101 101
- Page 103 103
- 858H823HFigure 5-18 104
- 862H825HFigure 106
- 6 BIOS Screens 108
- 6.1 Introduction 109
- Page 111 111
- 6.3 Advanced 112
- BIOS Menu 2: Advanced 113
- Page 115 115
- 877H840H6.3.2.1 appear 116
- Page 122 122
- DEFAULT 123
- Page 125 125
- CPU Fan PWM control 126
- Minimum Value: 0°C 126
- Maximum Value: 127°C 126
- Page 127 127
- Page 128 128
- 6.3.5 Power Configuration 128
- Page 129 129
- 6.3.5.1 ACPI configuration 129
- Page 131 131
- Page 133 133
- 6.3.7 Remote Configuration 133
- Page 135 135
- 6.4 PCI/PnP 138
- 6.5 Boot 140
- 6.6 Security 144
- 6.7 Chipset 145
- PCI/IGD DEFAULT 147
- Page 148 148
- 6.8 Exit 150
- Page 151 151
- 7 Software Drivers 152
- Page 153 153
- Page 154 154
- Page 155 155
- Page 156 156
- Page 157 157
- Page 158 158
- Page 159 159
- 7.4 VGA Driver Installation 160
- Page 161 161
- Page 162 162
- Page 163 163
- Page 164 164
- 7.5 LAN Driver Installation 165
- Page 166 166
- Page 167 167
- Page 168 168
- 7.6.1 HD Audio Installation 168
- Page 169 169
- Page 170 170
- Page 171 171
- Page 172 172
- Page 173 173
- Page 174 174
- A BIOS Menu Options 175
- B Terminology 179
- Page 180 180
- Page 181 181
- Page 182 182
- Page 183 183
- C DIO Interface 184
- C.2 DIO Connector Pinouts 185
- D Watchdog Timer 187
- E Address Mapping 190
- E.1 I/O Address Map 191
- Page 192 192
- E.2 IRQ Address Map 193
- E.3 Memory Address Map 193
- F Hazardous Materials 194
- Disclosure 194
- Page 195 195
Související produkty a manuály pro Hardware Iei-integration PICOe-945GSE
Hardware Iei-integration PICOe-GM45A Uživatelský manuál
(198 stránky)
(198 stránky)
Hardware Iei-integration PICOe-B650 Uživatelský manuál
(156 stránky)
(156 stránky)
© 2020, manymanuals.cz. Všechna práva vyhrazena. | 0.119 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce