Iei-integration KINO-QM57A Uživatelský manuál stáhnout pdf (Strana 67)

KINO-QM57A Mini-ITX SBC

Page 53

4.4.3 SO-DIMM Installation

To install an SO-DIMM, please follow the steps below and refer to Figure 4-4.

Figure 4-4: SO-DIMM Installation

Step 1: Locate the SO-DIMM socket. Place the board on an anti-static mat.

Step 2: Align the SO-DIMM with the socket. Align the notch on the memory with the

notch on the memory socket.

Step 3: Insert the SO-DIMM. Push the memory in at a 20º angle. (See

Figure 4-4)

Step 4: Seat the SO-DIMM. Gently push downwards and the arms clip into place. (See

Figure 4-4)

4.5 Jumper Settings

NOTE:

A jumper is a metal bridge used to close an

electrical circuit. It consists of two or three metal

pins and a small metal clip (often protected by a

plastic cover) that slides over the pins to connect

them. To CLOSE/SHORT a jumper means

connecting the pins of the jumper with the plastic

clip and to OPEN a jumper means removing the

plastic clip from a jumper.

Figure 4-5: Jumper Locations

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 163 164

Žádné komentáře

Iei-integration KINO-QM57A Uživatelský manuál Strana 67