Iei-integration EC-1040G Uživatelský manuál stáhnout pdf (Strana 43)

EC-1040GB Workstation

Page 33

Figure 4-9: 3.5” Disk Drive Retention Screws

4.5.7 Reinstall the Drive Brackets

After the drives have been installed, reinstall the drive brackets into the chassis.

NOTE:

It might be easier to connect the disk drive IDE/SATA connectors to the ribbon

cables and the disk drive power connectors to the PSU before the drive

brackets are reinstalled into the chassis.

Step 1: Remount the drive brackets in the original position they were removed from.

Step 2: Make sure all drive bracket retention screw holes are properly aligned with the

corresponding retention screw holes in the workstation.

Step 3: Reinsert all drive bracket retentions screws. Step 0:

4.5.8 Install the Backplane

To install a backplane, follow the instructions below.

Step 1: Install the correct amount of copper pillars into the base of the chassis

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 84 85

Žádné komentáře

Iei-integration EC-1040G Uživatelský manuál Strana 43