Iei-integration AFL2-12A-D525 Uživatelský manuál stáhnout pdf (Strana 60)

AFL2-12A-D525 Series Panel PC

Page 60

Pin Description Pin Description

4 RTS3 8 RI3

Table 4-2: Ethernet Connector Pinouts

Figure 4-21: Ethernet Connector

Follow the steps below to connect a serial device to the RJ-45 serial port connector of the

AFL2-12A-D525 panel PC.

Step 1: Locate the RJ-45 serial port. The location of the RJ-45 serial port is shown in

Chapter 2.

Step 2: Connect the RJ-45 to COM port cable to the panel PC. Insert the RJ-45

connector end of cable into the RJ-45 serial port. See

Figure 4-22

Step 3: Connect the serial device. Connect a serial device to the DB-9 connector end

of the cable. See

Figure 4-22

Figure 4-22: RJ-45 Serial Port Connector

Step 4: Secure the connector. Secure the serial device connector to the external

interface by tightening the two retention screws on either side of the connector.

Step 0:

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 179 180

Žádné komentáře

Iei-integration AFL2-12A-D525 Uživatelský manuál Strana 60