Iei-integration AFL-4 series-N270 v1.05 Uživatelský manuál stáhnout pdf (Strana 49)

AFL-4 Series-N270 User Manual

Page 49

Figure 4-4: AFL-412A/AFL-415A/AE HDD Retention Screws

Step 4: Connect the SATA cable to the rear of HDD and the SATA connector on the

motherboard.

Step 5: Install the HDD into the AFL-412A/AFL-415A/AE by aligning the retention screw

holes in the HDD brackets with the retention screw holes on the chassis. Insert

the four retention screws.

Step 6: Replace the aluminum back cover to the chassis.

Step 7: Replace the plastic back cover. Step 0:

4.8 AT/ATX Mode Selection

AT and ATX power modes can both be used on the AFL-4 Series-N270. The selection is

made through an AT/ATX switch on the bottom panel (

Figure 4-5). To select AT mode or

ATX mode, follow the steps below.

Step 1: Locate the AT/ATX switch on the bottom panel (

Figure 4-5).

Figure 4-5: AT/ATX Switch Location

Step 2: Adjust the AT/ATX switch. Step 0:

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 164 165

Žádné komentáře

Iei-integration AFL-4 series-N270 v1.05 Uživatelský manuál Strana 49