Iei-integration ACT-457A Uživatelský manuál stáhnout pdf (Strana 23)

ACT-457A Panel PC

Page 15

2.3 Installation and Configuration Steps

The following installation steps must be followed.

Step 1: Unpack the ACT-457A

Step 2: Install SD card (if not pre-installed)

Step 3: Configure the system

Step 4: Connect peripheral devices to the bottom panel of the ACT-457A.

Step 5: Mount the ACT-457A Step 0:

2.4 Rear Panel Removal

To access the jumpers and connectors, the rear panel must be removed.

Step 1: Place the ACT-457A monitor side down on a flat surface.

Step 2: Remove the rear panel screws and lift the back cover off. Step 0:

Figure 2-1: Rear Panel Retention Screws

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 66 67

Žádné komentáře

Iei-integration ACT-457A Uživatelský manuál Strana 23